Customer Video Submissions - March

Bebe Fashion Show at Club Sway

Gear used:
-MiniDV Stabilizer Pro
-Qalumet quick release
-Canon t3i
-Tokina 11-16 F2.8 lens 

Submitted by:
 Iskko Iskkov

Joelle - Big In LA (Showcase Mix) Full Credits

LA scenes were shot with our Specter Stabilizer and a Fujifilm X10 
Music video by Joelle performing Big In LA (Showcase Mix). © 2012 Camboso Ltd 


SHERLOCK HOLMES- "CASE OF THE THIRD SHOT" BY DRIZZY DRO(Canon 6D)


Submitted by: CottonFilms
http://www.facebook.com/cottonfilms
Filmed with our Specter Stabilizer

CONMAN ft. Khan Quest "Headphones & Notebook" (Prod. by Team One Studios) (HD)


Submitted by: Ted Cole
http://www.facebook.com/tedcolep
Filmed with our MiniDV Stabilizer

Comments

Post a Comment

Popular posts from this blog

DIY Camera Stabilizer Build - The Stabilizer Base Plate

Image
You're probably asking yourself why we chose to start off our DIY stabilizer build series with a part that seems so simple.  Just strap on a plate with some weights and move on right?  This is a part that regularly gets neglected, both in DIY rigs and Commercial stabilizers as well.  The base plate actually serves several key functions, so in the quest for a more stable rig spending some time on the design of your base plate is well worth it. Its the mounting point for your Counter-Weights If designed it can be used as a stand for smaller rigs It controls the inertia of the stabilizer - Key factor   Material Anything from wood to plastic to metal works as long as it's strong enough.  It needs to be able to support the counter-weights, and if you plan on using it as a stand keep the stabilizer upright.  We prefer to use ABS plastic sheet because it's both strong and light weight.  If you go with a 3/8" thick sheet like we offer in our D...
Read more

3-Axis Camera Stabilizer Gimbal

Image
Over the course of several hours thirty four different parts come together to produce just one of the high precision 3-axis camera stabilizer gimbals found in our Specter Stabilizer .   For precise alignment of the mounting holes, the middle layer of the gimbal starts out as a square .   Once the holes are drilled and threaded the corners are cut off prior to final rounding( Shown on right) . Designed with three layers that are machined together for a perfect fit, lighter weight, and calibration adjustment for perfect balance. .  It takes over seventy different parts to assemble just one of our Specter Stabilizers , seventeen of which are custom machined with tolerances of just a few thousandth of an inch. Here’s a close up look at just two of those custom parts found in the 3-axis gimbal. With high precision ultra low friction surfaces, the new fully ceramic main bearing will give you the super smooth footage you need. ...
Read more